|
Travel Assistance
Testronics is located in Richardson, Texas, which is about 20 miles north of Dallas (and about 45 miles east of the Dallas - Fort Worth Airport). Once you arrive at the airport, expect the drive to the plant (or area hotel) to take about an hour during off-peak traffic times and a little over an hour and a half between the peak traffic hours of 7:00 - 9:00 AM and 3:00 - 7:00 PM.
The Dallas-Fort Worth Airport (DFW) 
The DFW Airport is rather large and has rental car facilities at the airport as well as off-premises. The rental lots located at the airport maintain north and south facilities. Either will work, just make sure to take the north airport exit. This will get you headed in the right direction. If you use an off-premises rental agency, use their map to get you to either Highway 121 North or Loop 635.
DFW Airport Information
 Driving Directions 
There are two typical ways to get to Testronics from the DFW airport. Either
take Highway 121 north directly to McKinney, or take Loop 635 east to I-75 and then go
north to McKinney. Either way is about the same distance, (about 45 miles), but traffic is typically heavier
on Loop 635 during rush hour. Plan on the trip taking about an hour.
For both driving routes, you will want to take the north airport exit. When you exit, you will actually be on Highway 121, heading north. After about 1 mile, you can exit onto Loop 635 east or stay on 121.
To Testronics, via Highway 121
- Exit the airport through the north exit.
- Stay on 121 for about 40 miles. You
will go through Lewisville, underneath I-35, through a bunch of stop lights, and will
finally come up to I-75.
- At this point, 121 exits left and merges with I-75. Don't exit.
Continue going straight. This will be Highway 399 Spur, and will turn into highway 5 after
a mile or so.
- About 2 miles after the 121 / 399 split, you will come upon a stop light.
You will be on highway 5, (also called McDonald). This is the intersection of McDonald and
Industrial.
- Turn right onto Industrial and go for about 8 tenths of a mile.
- Turn left on Millwood.
- Our building is the last one on the left, about 1/2 a
mile.
 To Testronics, via Loop 635
- Exit the airport through the north exit.
- Follow the
signs to loop 635. You will stay on 635 for about 25 miles.
- Take the Interstate 75 north /
Sherman exit. This is a left hand exit, so stay to your left. You will then be heading
north on I-75. Continue north for about 15 miles. You will pass through Richardson, Plano,
and Allen.
- Take exit 38a from I-75. This exit is a big right turn putting you onto highway
399 Spur. About 2 miles after the exit, you will come upon a stop light. You will be on
highway 5, (also called McDonald). This is the intersection of McDonald and Industrial.
- Turn right onto Industrial and go for about 8 tenths of a mile.
- Turn left on
Millwood.
- Our building is the last one on the left, about 1/2 a mile.
View map of the Dallas area
View a zoomed-in map of the Testronics location
If you are staying at the Amerihost Inn, the following instructions may be helpful:
Directions to the Amerihost Inn (McKinney) from DFW Airport:
- Take the North exit out of the airport to 635 East Interchange
- Take 635 East to Highway 75 North (Central Expressway) Note: 75 is a left hand exit
75 North to McKinney, (approximately 33 miles)
- Exit 39A El Dorado Parkway
- Stay on the service road (parallels I75)
- After the exit keep to the right lane for 1 1/2 miles
- You will see Movies 14, Wilson Creek Skate Place, and then then the Amerihost Inn.
Direction from the Amerihost Inn to Testronics:
- Exit the rear of Amerihost turning right onto Wilson Creek Parkway
- Stay on Wilson Creek Parkway for approximately 3 miles
- At the intersection of Wilson Creek and McDonald, cross over McDonald. You are now on Elm.
- Follow Elm until it takes a sharp right hand turn, about .8 miles. You are now on Millwood.
- Testronics is the first building on the right.
Learn more about planning a visit.
|
